Duration and latency recording
Duration recording measures how long a behavior lasts. Latency measures how long it takes to start. Both use a clock rather than a tally, and both need a precise rule for when the timing starts and stops.
When duration fits
Use duration when the length of the behavior is what matters: tantrums, time on task, time out of seat, time spent engaged in play, crying. If the behavior is brief and countable, frequency is usually simpler.
Define the start and the end
The end is the hard part. "The tantrum ends when the student has been quiet and seated for 10 seconds" gives two observers the same stop time; "when they calm down" does not. Write both rules on the sheet.
Three numbers from the same data
From a list of start and stop times you can report:
| Measure | Formula | Answers |
|---|---|---|
| Total duration | Sum of all episodes | How much time did it take up? |
| Duration per occurrence | Total ÷ number of episodes | How long does each one last? |
| Percent of observation | Total ÷ observation length × 100 | What share of the time was it happening? |
Example: three tantrums of 1, 2 and 3 minutes during a 30-minute observation give a total of 6 minutes, an average of 2 minutes each, and 20% of the observation. If the goal is shorter tantrums, watch the average. If the goal is more time on task, watch the percent of observation.
Latency
Latency is the time from a cue (usually an instruction) to the start of the behavior: "Line up" at 10:02:00, the student is in line at 10:02:40, so the latency is 40 seconds. Record the time of the cue and the time the response started; the duration data sheet works if you treat the cue as the start time. Use latency when the problem is slowness to start, not whether the person does it at all.
SessionTap does not record latency as its own measure. You can approximate it by starting a duration button at the instruction and stopping it when the response begins, but the app will report it as a duration.
Common mistakes
- Rounding to the nearest minute for short episodes. Use a watch with seconds.
- Forgetting the observation length, which you need for percent of observation.
- Timing two behaviors with one stopwatch. If both matter, you need two timers, or an app that can run several at once.
On paper or on a phone
The free duration data sheet has 15 rows for start and stop times and the three summary formulas.
In SessionTap a duration button starts timing with one tap and stops with the next, and shows how long it has been running while it is on. Several can run at the same time, alongside frequency buttons. When the session ends you see the number of episodes, total time and percent of session for each, and the CSV has every episode's start, end and length in seconds. Timing is based on the clock, so it keeps going if the phone locks.